Baxi Eco 3 Wartungshandbuch PDF herunterladen (Seite 19)

8.0 Installation

8.6 Fitting The Flue

HORIZONTAL FLUE

1. The standard flue is suitable for lengths

100mm minimum to 1m maximum (measured

from the edge of the flue elbow outlet).

Rear Flue: maximum wall thickness - 900mm

Side Flue: maximum wall thickness - 870mm

2. Locate the flue elbow on the adaptor at the top

of the boiler. Set the elbow to the required

orientation (rear, right or left).

3. Measure the distance from the outside wall

face to the elbow (Fig. 27). This dimension will be

known as ‘X’.

4. Taking the air duct, mark dimension ‘X’ as

shown (Fig. 28). Measure the length of waste

material, and transfer the dimension to the flue

duct (Fig. 28).

5. Remove the waste from both ducts. Ensure

that the cut ends are square and free from burrs.

6. Remove the flue elbow from the adaptor.

IMPORTANT: Check all measurements before

cutting.

Wall Thickness

(X)

Wall Thickness

(X)

Fig. 27

Waste

(X)

Waste

Fig. 28

Air Duct

Flue Duct

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

Keine Kommentare

Baxi Eco 3 Wartungshandbuch Seite 19