5116113/01INSTALLER AND OWNER GUIDEThis guide is intended to help you install and care for your Baxi Fires Division electricheater. Please read caref
Method C - Screw fixing to a flat wall.If the heater is to be mounted on to a plasterboardwall that has a wooden frame behind it then theintegrity and
floor level.Fitting the heater.1. Decide the locationof the heater. 2. If the heater is to befixed in an elevatedposition (i.e. abovehearth or finishe
Fitting the fascia.1. There are two hooked brackets on the toprear of the fascia. Locate the hooks into thebrackets at the top of the heater (See figu
Chic fascia only.1. The lower section of the fascia is securedwith magnets. Locate it as in figure 15. Thebottom of the lower section should sit on th
2. Hang the lower trim at the bottom of the fascia (See figure 18).USING THE HEATERImportant SafetyNever cover the heater or obstruct the openings at
specifically excluded from the guarantee.To replace the light bulb.1. To gain access to the light bulb, remove the loose pebbles from the fuel support
4. I Have a problem that is different to those in the previous examples 1- 3.Below is a list of Useful Telephone numbersFor general advice about your
© Baxi Heating U.K. Limited 2005.All rights reserved. No part of this publication may be reproduced in any material form(including photocopying), stor
Safety First.Baxi Fires Division heaters are CE Approved and designed to meet the appropriateBritish Standards and Safety Marks.Quality and Excellence
!One person should be sufficient to lift the heater. If for any reason this weight is considered too heavy then obtain assistance.!When lifting always
FITTING THE HEATERThe installation of this heater requires a reasonable level of DIY skills.Please read this guide thoroughly before commencing instal
! The heater is supplied with a 3 pin 13 Amp fused re-wireable plug with 1mm² 3 corecable.! The wires in the cable are coloured inaccordance with the
If the electric cable is damaged, to avoid ahazard it must be replaced by a Baxi FiresDivision authorised service agent, orsimilarly qualified person
The heater must always be fixed into position to prevent it from being tipped overThe following fixing options are available:Chic, Envy, Serenity and
2. Mark the eyescrew position on the centre line atthe back of the fireplace opening and at a height of533-560mm (21 inches - 22 inches) (See figure 5
Kommentare zu diesen Handbüchern